ABB ACS880-17 - Page 103

Electrical installation 103
Powering the heating and lighting equipment (options +G300, +G301 and +G313)
See the circuit diagrams delivered with drive.
Connect the external power supply wires for the cabinet heater and lighting to terminal
block X300 at the back of the mounting plate. For the actual wiring, see the circuit diagram
delivered with the drive.
Connect the motor heater wiring to terminal block X313 as shown below. Maximum
external power supply 16 A. For the actual wiring, see the circuit diagram delivered with
the drive.
1
2
PE
4
5
N
L
X300
PE
1 Internal wiring of the cabinet heater: heater
off/fault = contact open.
1
1
2
3
4
5
6
7
PE2
PE1
N
L
N
L
X313
PE
1 Internal wiring of the motor space heater
supervision: load break switch or protection
switch off/fault = contact open.
1