ABB ACS880-17 - Replacing the LCL Filter Module

154 Maintenance
 Replacing the LCL filter module
If LCL filter module is also to be replaced:
1. To open the support legs 90 degrees, press each leg a little down and turning it aside.
2. To remove the lower support bracket of the LCL filter module, undo the two screws.
3. Adjust the extraction ramp to the correct height and attach it to the cabinet base with
the two mounting screws of the lower support bracket that was removed.
4. Undo the two lower screws that attach the LCL filter module to the cabinet from the
right.
5. For drives with
marine construction (option +C121): Undo the two lower screws that
attach the LCL filter module to the cabinet frame from back.
6. Undo the 5 bolts that attach LCL filter module from back and from the right to the
cabinet frame.
4
5
6
6
6
1
1
2
3