60 Mechanical installation
Moving the cabinet on rollers
WARNING: Do not move marine versions (option +C121) on rollers.
Lay the cabinet on the rollers and move it carefully until close to its final location. Remove
the rollers by lifting the unit with a crane, forklift, pallet truck or jack.
Moving the cabinet on its back
WARNING: Transportation of the cabinet on its back is only allowed if it is packed
for such transportation at the factory. Transportation of the cabinet on its back is
only allowed with the sine filters (option +E206) removed from the cabinet.
Transportation of the R11 cabinet on its back is only allowed with the drive and LCL filter
modules also removed from the cabinet.
If the cabinet needs to be laid on its back, support the cabinet from below alongside the
cubicle seams.
Cabinet back panel Support
To Next Page
Loading...
