Mechanical installation 65
Fastening the cabinet to the floor and wall or roof (marine
units)
Obey the general rules given in section General rules on page 63.
See the dimension drawing delivered with the drive for the locations of the fastening holes
in the flat bars below the cabinet and for fastening points at the top of the cabinet. Top
fastening brackets are included in the delivery.
Fasten the cabinet to the floor and roof (wall) as follows:
1. Bolt the unit to the floor through the holes in each flat bar at the base of the cabinet
using M10 or M12 screws.
2. If there is not enough room behind the cabinet for installation, clamp the rear ends of
the flat bars to the floor.
3. Remove the lifting eyes and bolt the fastening brackets into the lifting eye holes.
Fasten the top of the cabinet to the rear wall and/or roof with brackets.
M16
2. Clamping the cabinet to the
floor at the back
aClamp
b Back panel of cabinet
c Flat bars at base of cabinet
3. Fastening the cabinet at the
top
d Fastening bracket
a
b
c
2
3
d
To Next Page
Loading...
