ABB ACS880-17 - Case 2: FSO-XX Safety Functions Module Next to the Control Unit

112 Electrical installation
Case 2: FSO-xx safety functions module next to the control unit
Install the safety functions module next to the control unit as described below. Change the
original mounting plate of the module to the alternative plate included in the module
package.
WARNING! Obey the instructions in chapter Safety instructions. If you ignore
them, injury or death, or damage to the equipment can occur.
1. Stop the drive and do the steps in section Electrical safety precautions (page 16)
before you start the work.
2. Open the doors
3. Attach the FSO-xx safety functions module to the mounting plate with four screws.
4. Tighten the FSO-xx electronics grounding screw o 0.8 N·m. Note: The screw tightens
the connections and grounds the module. It is essential for fulfilling the EMC
requirements and for proper operation of the module.
5. Connect the FSO-xx data cable to FSO-xx connector X110 and to connector X12 on
the control unit.
3
3
3
3
4
5
5