176 Technical data
CE marking
A CE mark is attached to the drive to verify that the drive complies with the provisions of
the European Low Voltage and EMC Directives. The CE marking also verifies that the
drive, in regard to its safety functions (such as Safe torque off), conforms with the
Machinery Directive as a safety component.
Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has been verified according to
standard EN 61800-5-1.
Compliance with the European EMC Directive
The EMC Directive defines the requirements for immunity and emissions of electrical
equipment used within the European Union. The EMC product standard (EN 61800-
3:2004) covers requirements stated for drives. See section Compliance with EN 61800-
3:2004 below.
Compliance with the European Machinery Directive
The drive is an electronic product which is covered by the European Low Voltage
Directive. However, the drive includes the Safe torque off function and can be equipped
with other safety functions for machinery which, as safety components, are in the scope of
the Machinery Directive. These functions of the drive comply with European harmonized
standards such as EN 61800-5-2. The declaration of conformity is shown below.
EMC performance
IEC 61800-
3:2004/A1:2011
EN 61800-3/A1:2012
Adjustible speed electrical power drive systems. Part 3: EMC requirements and
specific test methods
To Next Page
Loading...
