Maintenance 151
14. To open the support legs 90 degrees, press each leg a little down and turn it aside.
15. To remove the lower support bracket of the drive module, undo the two screws.
16. Adjust the extraction ramp to the correct height and attach it to the cabinet base with
the two mounting screws of the support bracket that was removed.
17. For drives with
marine construction (option +C121): Remove the bolts that attach the
drive module to the cabinet frame at the lower part.
Combi screw M8,
24 N·m (17 lbf·ft)
14
15
15
16
16
17
17
To Next Page
Loading...
