10-8 Chapter 10: Status Messages, Troubleshooting 42/24-10 EN Rev. 9
Status Messages, continued
No. Text O E M F Reaction /Remark
Runtime Error
1–21 Runtime Error 1 to 21 Notify service if these status messages occur repeatedly.
System Controller
101 System controller shut down
at
For information; shows date and time
102 System controller starts up at For information; shows date and time as well as warm start
or cold start
103 Installing Module: For information
104 Removing Module: For information
105 Reactivating Module: For information
106 A user installed module: For information
107 A user removed module: For information
108 A user replaced module: For information
109 A password is active! To
delete, press the <MEAS> key
on the measurement value
display.
Not logged
110 System booting. Not logged
111 This system is temporarily
under remote control!
Not logged
112 Display/control unit
synchronizing with analyzer.
Please wait.
Not logged
113 The system time was changed
from -> to:
Not logged
114 The system is saving the
changed parameters. Please
wait!
116 The Profibus Module is
mounted on the wrong slot!
The Profibus interface is not
working. Please remount the
Profibus Module on slot
X20/X21.
x x
117 The configuration backup was
saved.
118 The configuration backup was
loaded. The system has been
restarted.
119 The system configuration
could not be loaded! This
system contains no configu-
ration now. Please enter menu
Configure/System/Save confi-
guration to load your backup
configuration. Or use SMT to
re-install your configuration.
Continued on next page
To Next Page
Loading...
