42/24-10 EN Rev. 9 Chapter 6: Gas Analyzer Operation 6-3
Message Display
Message Display
Functions
The blinking message display in the softkey line has the following functions:
• It prompts for the STATUS MESSAGE key to be pressed whenever a status
message appears (refer to the “System Status: Status Messages” section,
page 10-2).
• It shows that a password is active (refer to the “Password Protection” section,
page 6-12).
• It shows that the gas analyzer is being controlled from a remote HMI (refer to the
“User Interface Priority” section, page 6-15).
• It shows that an automatic calibration process is running in the gas analyzer
(refer to the “Automatic Calibration” section, page 8-A-4).
Display of Status
Messages
When a status message is generated by the Message Generator function block its
text is displayed as configured in the function block. For a complete description of
the function block, see the “AO2000 Function Blocks – Descriptions and Configu-
ration” technical bulletin (Publication No. 30/24-200 EN).
To Next Page
Loading...
