42/24-10 EN Rev. 9 Chapter 7: Gas Analyzer Configuration 7-A-9
Changing Module Name
Menu Path MENU → Configure → Component-specific → Module text
Module Name
The module name is shown in the display next to the module type. Here you can
enter a name relating to the measuring point, for example.
Monolingual or
Bilingual
The module name can be entered independent of the language of the user
instructions (see page 7-C-2) or separately for both languages.
Text Length The length of the text for the module name is:
• limited to 24 characters for a monolingual entry, and
• limited to two times 10 characters for a bilingual entry.
Entering the Module
Name
When entering the module name, use the same procedure as entering text (see
page 6-9).
The changed module name is shown in the display after switching to measuring.
If the module name appears next to or under the module type depends on the
configured size for displaying the measured quantity (see the “Display” section,
page 7-D-1).
To Next Page
Loading...
