ABB Advance Optima magnos206 - Operating by Value Entry

6-10 Chapter 6: Gas Analyzer Operation 42/24-10 EN Rev. 9
Operating by Value Entry
Value Entry Values are entered during measurement mode by pressing the number key that
corresponds to the position of the display element in the display and is indicated
above the display element. In the example below, this is key 4 (see Fig. 6-2).
A field then appears for entering the value (see Fig. 6-3).
Fig. 6-2
Value Entry:
Display During
Measurement Mode
(Example: Setting the
Pump Output)
Fig. 6-3
Value Entry:
Entering a Value
(Example)
Description and
Configuration
The display element Value Entry is described on page 7-D-10.
The configuration is described on page 7-D-11.