ABB Advance Optima magnos206 - Page 256

A-4-2 Appendix 4: Index 42/24-10 EN Rev. 9
Index, continued
Calibration cells
Limas11 7-A-3, 8-C-5
Uras26 7-A-3, 8-C-13
Measurement 9-7
Calibration data 8-B-1
Automatic calibration 8-B-3
Calibration data sub-menu 8-B-1
Externally controlled calibration 8-B-6
Manual calibration 8-B-2
Output current response 8-B-6
Calibration method 8-A-10
→ Calibration data
Calibration reset 9-29
Cancel keys 6-6
Carrier gas alignment 9-32
Central unit A-1-1
Housing purge 3-12
CLEAR key 6-8
Common calibration 8-A-10
Configuration 7-A-1
Saving 7-C-10
Connection box (IP54 version) 4-13
Control signals
Automatic calibration 8-A-4
Externally controlled calibration 8-A-9
Cross sensitivity alignment 9-31
Cross sensitivity correction
Limas11 8-C-6
Uras26 8-C-14
Current range
Changing 9-26
Cycle time
for automatic calibration 8-B-3
D
Dampening (T90 time)
→ Filter
Date
of next automatic calibration 8-B-3
Setting (system) 7-C-1
Decimal places
Changing the number 7-A-4
Digital I/O board
→ I/O boards
Digital I/O module
→ I/O modules
Dimensional diagrams 2-4
Display and control unit 6-1, A-1-4
Cancel keys 6-6
Numeric keypad 6-5
Operating modes 6-1
Screen 6-2
Softkeys 6-7
Status LED’s 6-4, 10-4
Disposable filter in the gas module
Replacing 9-24
Drift 9-29
E
Electrical connections
2-way analog output module 4-4
4-way analog output module 4-5
4-way analog input module 4-6
Digital I/O module 4-7
Electronics module 4-1
Modbus module 4-3
Profibus module 4-2
Electrical safety A-2-8
Electromagnetic compatibility A-2-8
Electronics module A-1-3
Connection diagram 4-1
ENTER key 6-8
Environmental conditions 1-1
Error LED 6-4
Error messages
→ Status messages
Ethernet connection configuration 7-C-12
Exhaust gases
Evacuate 3-13
ZO23 A-3-6
Explosion-protected version xiii
Explosion protection A-1-1
External control
→ Calibration (automatic)
→ Calibration (externally controlled)
Continued on next page