vi AO2000 Series Operator’s Manual 42/24-10 EN Rev. 9
Table of Contents, continued
Page
Chapter 9 Inspection and Maintenance
Inspection 9-1
Checking Gas Path Seal Integrity 9-2
Magnos27: Thermal Link Replacement 9-3
Uras26: Optical Alignment 9-4
Uras26: Phase Alignment 9-6
Limas11, Uras26: Measurement of Calibration Cells 9-7
Limas11, Uras26: Relinearization 9-8
Limas11: Thermal Link Replacement 9-9
Limas11: Aluminum Sample Cell Cleaning 9-10
Limas11: Quartz Sample Cell Cleaning 9-12
Limas11: Safety Cell Cleaning 9-15
Limas11 UV: Lamp (EDL) Replacement 9-21
Limas11: Amplification Optimization 9-23
Gas Module: Disposable Filter Replacement 9-25
Pump Activation, Pump Output Adjustment 9-26
Changing Analog Output Current Range 9-27
Air Pressure Correction 9-28
Air Pressure Value Correction 9-29
Calibration Reset 9-30
Basic Calibration 9-31
Cross-Sensitivity Alignment 9-32
Carrier Gas Alignment 9-33
Chapter 10 Status Messages, Troubleshooting
Process Status 10-1
System Status: Status Messages 10-2
System Status: Status Signals 10-4
Status Message Categories 10-5
Status Messages 10-7
Gas Analyzer Problems 10-18
Caldos25, Caldos27, Magnos206, Magnos27 Problems 10-20
Limas11 Problems 10-21
Uras26 Problems 10-22
Gas Module Problems 10-23
Notify Service 10-24
Chapter 11 Gas Analyzer Shutdown and Packing
Gas Analyzer Shutdown 11-1
Preparing the Gas Analyzer for Shipping and Packing 11-2
Continued on next page
To Next Page
Loading...
