ControlMaster CM10, CM30 and CM50
Universal process controllers,
1
/8,
1
/4 and
1
/2 DIN 7 Advanced Level
IM/CM/S–EN Rev. R 85
…Functions / …Math Blocks
Real Time Average Setup
Source 1
(RTA Source)
Selects the source for real time average calculation – see Appendix A, page 116 for description
of sources.
Reset Source Select the digital source required to reset the internal accumulative value and timer.
This does not change the immediate output of the math block but restarts the calculation of the
next average value – see Appendix A.1, page 116 for digital sources.
Average Duration Sets the time duration the average is calculated over.
The output value of the math block is updated at this rate.
Max Hold / MinHold Setup
Source 1 Selects the source for maximum or minimum value calculation – see Appendix A, page 116 for
description of sources.
Reset Source Select the digital signal to be used to reset the maximum or minimum value.
To Next Page
Loading...
