ControlMaster CM15 and CMF160
Universal process indicator
1
/8 DIN 7 Advanced Level
36 IM/CM/I–EN Rev. P
…Device Setup / …Initial Setup
Custom Template If this parameter is enabled, it enables the internal function blocks to be re-linked to create custom
configurations for special application requirements.
These sources are configured in Device Setup / Custom Config – see page 37.
Analog 1 Eng. Units
Analog 2 Eng. Units
Configurable units that can be assigned to any analog signal
(Analog I/P or Math Block).
Tot. 1 Eng. Units
Tot. 2 Eng. Units
Configurable units that can be assigned to any totalizer.
Stats. Reset Source Sets the digital source signal used to reset the statistics.
Reset to Defaults Resets all configuration parameters to their default values.
Security Setup 2 Security access levels are provided, each protected by a password of up to 6 alphanumeric
characters.
Note. Passwords are not set at the factory and must be entered by the end user(s).
Basic Password Basic level provides access to the Basic level.
Advanced Password Provides access to Advanced configuration parameters – see Section 7, page 34.
Reset Passwords Resets all passwords to factory values.
To Next Page
Loading...
