ABB FEX300 - Page 11

Safety
OI/FEX300/FEX500-EN FEX300, FEX500 11
1.6.2.2 Name plate for the remote design
Fig. 2: Remote design
1 Model number (for more detailed information about
the technical design, refer to the data sheet or the
order confirmation)
2 Order no.
3 Meter size and nominal pressure rating
4 Material: Flange/lining/electrode
5 Client-specific TAG number (if specified)
6 T
med
= maximum permissible fluid temperature
T
amb
= maximum permissible ambient temperature
7 Protection type according to EN 60529
8 Calibration value Qmax DN
9 Calibration value Ss (span)
Calibration value Sz (zero point)
10Year of manufacture
11CE mark
12Serial number for identification by the manufacturer
13Supplementary information: EE = grounding
electrodes, TFE = partial filling electrode
14Accuracy to which the unit was calibrated (e.g., 0.2%
of rate)
15Excitation frequency of sensor coils
16Label indicating whether the unit is subject to the
Pressure Equipment Directive (PED).
Information on the relevant fluid group.
Fluid group 1 = hazardous fluids, liquid, gaseous.
(Pressure Equipment Directive = PED).
If the pressure equipment is not subject to the
Pressure Equipment Directive 97/23/EC, it is
classified in accordance with SEP (= sound
engineering practice) as per Art. 3 Para. 3 of the PED.
If no such information is present, it means that the
device does not claim to comply with the requirements
of the Pressure Equipment Directive 97/23/EC. Water
supplies and connected equipment accessories are
classed as an exception in accordance with guideline
1/16 of Art. 1 Para. 3.2 of the Pressure Equipment
Directive.
Important (Notice)
Meters with 3A approval are labeled with an additional plate.