ABB FEX300 - Table of Contents

Contents
OI/FEX300/FEX500-EN FEX300, FEX500 3
1
Safety.............................................................................................................................................................7
1.1 General information and notes for the reader ................................................................................................7
1.2 Intended use...................................................................................................................................................8
1.3 Improper use ..................................................................................................................................................8
1.4 Target groups and qualifications ....................................................................................................................8
1.5 Warranty provisions........................................................................................................................................8
1.6 Plates and symbols ........................................................................................................................................9
1.6.1 Safety-/ warning symbols, note symbols.................................................................................................9
1.6.2 Name plate............................................................................................................................................10
1.7 Transport safety information.........................................................................................................................13
1.8 Installation safety information.......................................................................................................................13
1.9 Safety instructions for electrical installation .................................................................................................13
1.10 Safety instructions for operation...................................................................................................................14
1.11 Technical limit values ...................................................................................................................................14
1.12 Allowed Fluids ..............................................................................................................................................14
1.13 Maintenance and inspection safety information...........................................................................................15
1.14 Returning devices.........................................................................................................................................15
1.15 Integrated management system...................................................................................................................16
1.16 Disposal........................................................................................................................................................16
1.16.1 Information on WEEE Directive 2002/96/EC (Waste Electrical and Electronic Equipment).................16
1.16.2 RoHS Directive 2002/95/EC .................................................................................................................16
2 Design and function...................................................................................................................................17
2.1 Measuring principle ......................................................................................................................................17
2.2 Device designs .............................................................................................................................................18
2.2.1 Design ...................................................................................................................................................19
2.2.2 Model with compact design...................................................................................................................19
2.2.3 Model with remount mount design........................................................................................................19
3 Transport and storage ...............................................................................................................................20
3.1 Inspection .....................................................................................................................................................20
3.2 Transport of flanged units smaller than DN 450...........................................................................................20
3.3 Transport of flanged units larger than DN 400.............................................................................................21
3.4 Storage conditions........................................................................................................................................21
4 Mounting .....................................................................................................................................................22
4.1 General information on installation...............................................................................................................22
4.1.1 Supports for meter sizes larger than DN 400 .......................................................................................22
4.1.2 Mounting the measuring tube ...............................................................................................................23
4.2 Torque information .......................................................................................................................................24
4.2.1 ProcessMaster in flange design and HygienicMaster in flange or wafer-type design ..........................24
4.2.2 Variable process connections HygienicMaster .....................................................................................28
4.3 Information on EHEDG conformity...............................................................................................................29
4.4 Information on 3A conformity .......................................................................................................................29
4.5 Installation Requirements.............................................................................................................................30
4.5.1 Electrode axis........................................................................................................................................30
4.5.2 In- and outlet pipe sections ...................................................................................................................30
4.5.3 Vertical connections..............................................................................................................................30
4.5.4 Horizontal connections..........................................................................................................................30
4.5.5 Free inlet or outlet .................................................................................................................................30
4.5.6 Strongly contaminated fluids.................................................................................................................30
4.5.7 Installation in the vicinity of pumps .......................................................................................................31
4.5.8 Installing the high temperature design..................................................................................................31
4.5.9 Devices with extended diagnostic functions .........................................................................................31