ABB FEX300 - Menu: Display

Parameterization
OI/FEX300/FEX500-EN FEX300, FEX500 101
7.4.4 Menu: Display
Menu / Parameter Value range Description
Display
Language
Deutsch, English, Français,
Español, Italiano, Dansk,
Svenska, Polski, Russki,
Zhongweng, Turkce
Select the menu language.
Contrast 0 ... 100 % Contrast setting for the LCD display
Operator Pages
Select the "Operator Pages" submenu.
Important (Notice)
Up to four user-specific operator pages (layouts)
can be configured for the process display. If
several operator pages have been configured,
these can be scrolled manually
. In the factory
setting only Operator Page 1 is enabled.
Autoscroll On / Off
If Multiplex mode is enabled, you can also activate the
"Autoscroll" function on the information level.
In this function, operator pages appear on the LCD
window in ten-second intervals. Manual scrolling
through pre-configured operator pages as described
above is no longer necessary.
When Autoscroll mode is enabled, the  icon is
displayed on the lower left.
Default setting: Off
Flowrate Format
x, x.x, x.xx, x.xxx, x.xxxx
Select the decimal places for the flow indicator.
Default setting: x.xx
Volume Format
x, x.x, x.xx, x.xxx, x.xxxx
Select the decimal places for the flow totalizer.
Factory setting: x.xx
Date/Time Format
DD-MM-YYYY, MM-DD-
YYYY, YYYY-MM-DD
Set the display format for the date and time. Factory
setting: YYYY-MM-DD
Display Test
Start the test of the LCD display with "OK".
Display / Operator Pages
Operator Page 1
Select the "Operator Page 1" submenu.
Operator Page 2
Select the "Operator Page 2" submenu.
Operator Page 3
Select the "Operator Page 3" submenu.
Operator Page 4
Select the "Operator Page 4" submenu.
italics = Parameter can only be viewed at the "Advanced" password level.
1) Parameter / menu only available for FEP500 / FEH500.