ABB FEX300 - Selecting and Changing Parameters

Parameterization
80 FEX300, FEX500 OI/FEX300/FEX500-EN
7.2.5 Selecting and changing parameters
7.2.5.1 Entry from table
When an entry is made from a table, a value is selected from a list of parameter values.
Menu name
Parameter name
Value currently set
Next Edit
1. Select the parameters you want to set in the menu.
2. Use
to call up the list of available parameter
values. The parameter value that is currently set is
highlighted.
Parameter name
Parameter 1
Parameter 2
Parameter 3
Cancel OK
3. Use
or to select the required value.
4. Use
to confirm your selection.
This concludes the procedure for selecting a parameter
value.
7.2.5.2 Numerical entry
When a numerical entry is made, a value is set by entering the individual decimal positions.
----Menu name----
Parameter name
12.3456 [unit]
Next Edit
1. Select the parameters you want to set in the menu.
2. Use
to call up the parameter for editing. The
position that is currently selected is highlighted.
-----Parameter name----
12.3456 [unit]
Next OK
3. Use
to select the decimal position to be changed.
4. Use
or to set the required value.
5. Use
to select the next decimal position.
6. If necessary, select and set other decimal positions
using the same procedure as described in steps 3 and
4.
7. Use
to confirm your setting.
This concludes the procedure for changing a parameter
value.