ABB FEX300 - Overview of Parameter Settings (Factory Settings)

Appendix
OI/FEX300/FEX500-EN FEX300, FEX500 171
15.3 Overview of parameter settings (factory settings)
Possible parameter settings Factory setting
Sensor TAG Alphanumeric, max. 20 characters None
Sensor Location TAG Alphanumeric, max. 20 characters None
Qmax Depending on nominal diameter
(see table in Section 6.6)
QmaxDN (see table in Section
6.6)
Q (Flowrate) Unit l/s; l/min; l/h; ml/s; ml/min; m3/s; m3/min;
m3/h; m3/d; hl/h; g/s; g/min; g/h; kg/s;
kg/min; kg/h; kg/d; t/min; t/h; t/d
l/min
Totalizer/Pulse Unit m3; l; ml; hl; g; kg; t l
Pulses per Unit 1
Pulse Width 0,1 ... 2,000 ms 100 ms
Damping ( 1 Tau) 0,02 ... 60 sec. 1
DO1 Alarm Config Pulse F/Pulse R, Pulse F, General Alarm,
Min. Flowrate Alarm, Max. Flowrate Alarm,
Empty Pipe, TFE, Only available for
FEP500 / FEH500 are: Gas Bubble,
Conductivity, Coating, Sensor Temp,
Signal
Pulse F/Pulse R
DO1 Drive Active, Passive Passive
DO2 Alarm Config
F/R Signal, Pulse R, General Alarm, Min.
Flowrate Alarm, Max. Flowrate Alarm,
Empty Pipe, TFE, Only available for
FEP500 / FEH500 are:
Gas Bubble, Conductivity, Coating, Sensor
Temp, Signal
F/R Signal
Digital Input DI No Function, Totalizer Reset(All), Flowrate
to Zero, System Zero Adjust, Totalizer
Stop(All), Only available for
FEP500 / FEH500 are:
Switchover Dual Range, Start/Stop
Batching
Flowrate to Zero
Current Output 4 … 20 mA, 4 … 12 … 20 mA 4 … 20 mA
Iout at Alarm (in accordance with
NE43)
High alarm, adjustable to 21 … 23 mA or
Low alarm, adjustable to 3.5 … 3.6 mA
High alarm, 21.8 mA
For details refer to Section 9.2.
Iout at Flow >103% Off (no signaling, current output remains at
20.5 mA), high alarm, low alarm
Off
Low Flow Cut Off
0 … 10 % 1 %
Empty Pipe Detector
On / Off Off
TFE Detector
On / Off Off
15.3.1 For Profibus PA version
Possible parameter settings Factory setting
PA Addr. (BUS)
0 ... 126 126
Ident Nr. Selector 0 x 9700, 0 x 9740, 0 x 3430 0 x 3430