ABB FEX300 - Page 83

Parameterization
OI/FEX300/FEX500-EN FEX300, FEX500 83
Amplifier Analog Range
Adjust CMReject
CMR Value
Adjust Gain 1...64
Adjust Gain 1
Adjust Gain 8
Adjust Gain 32
Adjust Gain 64
Transmitter
Device Version
ScanMaster option
Tx Type
Tx Span
Tx Zero
Offset Iout
Gain Iout
Simulator
Transmitter ID
SAP / ERP No.
Tx Version
TX Run Hours
TX Firmware Ver.
TX Hardware Ver.
Com Controller Ver.
Bootloader Ver.
Calibration
First Cal. Date
Last Cal. Date
Cal. Cert. No.
First Cal. Location
Last Cal. Location
Manufacturer
Street
City
Phone
Device Setup 3 Access Control
Standard Password
Advanced Password
Read Only Switch
Custody Switch
Sensor
QmaxDN
Qmax
Qmax 2
Range Mode
Sensor Location TAG
Sensor TAG
Transmitter Units
Damping
Density
Totalizer/Pulse Unit
Q (Flowrate) Unit
Velocity Unit
Custom Vol. Type
Custom Vol. Factor
Custom Vol. String
Custom Tot. Type
Custom Tot. Factor
Custom Tot. String
Low Flow Cut Off
Flow Cut Off Level
Hysteresis
TX Location TAG
TX TAG
italics = Parameter can only be changed at the "advanced" password level.