3.11 Analog I/O (option) 3:30
3.11.1 Analog Ports
3.11.2 Analog Connections
3.11.3 Combined I/O (option)
3.11.4 Connection table - Combined I/O
3.12 Arc weld I/O (option) 3:37
3.12.1 General
3.12.2 Servo-controlled positioner with common drive unit
3.13 Program printout (option) 3:41
3.14 Computer link (option) 3:42
3.15 External operating panel (option) 3:43
3.17 I/O signals - SWI (Spot Welding, Interface) 3:45
4 MAINS CONNECTION AND START-UP 4:1
4.1 Connection to mains terminal 4:1
4.1.1 Connection on left hand side
4.1.2 Mains Transformer
4.2 Check-list before start-up 4:3
4.3 Start-up to standby 4:3
5 SYSTEM PARAMETERS 5:1
5.1 Introduction 5:1
5.1.1 Handling system parameters
5.1.2 Handling parameter menus
5.1.3 Handling stored parameters to/from a diskette
5.1.4 Handling stored parameters to/from a superior computer
5.1.5 Concluding procedures
5.2 Individual system parameters 5:6
5.2.1 Parameters, menus and submenus
5.2.2 Loading parameters from a PROM
5.2.4 Individual system parameters
5.2.4.2-
5.2.4.32 Description of individual system parameters
5.3 Resolver calibration 5:59
5.3.1 Resolver data in general
5.3.2 Basic menu and submenus
5.3.3 Handling of calibration parameters
5.3.4 COMMOFF. Commutation offset
5.3.5 SYNCOFF. Synchronizing offset
5.3.6 COUNT
5.4 Test running 5:65
INSTALLATION
0:2
To Next Page
Loading...
