3.15
External operating panel (option)
The following devices can be placed in an external panel outside the control system:
• Operating panel
• Holder for programming unit
• LCD monitor (option)
When the external operating panel is specified the units above are delivered separately,
together with the necessary wiring, sealing strips, screws etc. and to be mounted together in
an external panel enclosure. Cover plates are mounted on the control system.
The external panel enclosure must be in accordance with the requirements of IEC
144 and IEC 529 Degree of protection rating IP 54 (NEMA12).
See the dimensioned figure below for the mechanical assembly:
58,
18,54
202
34,5
D=3.4 (x4)
2
Hole for LCD
monitor
(option)
320
224
max 3)
Hole for
operating
panel
kz 12
(mm)
200
Hole for flange
M8 (x4)
Hole for programming unit connectoi
193
D=2.W
INSTALLATION
3:43
S3
To Next Page
Loading...
