(MANUAL + SCAN)
1
CHANGE FRDISK TO DISK RESOLV SCAN
5.2
5.1.3 5.1.3 5.3
5.1.4
5.1.4
The notations under the menu show in which section the parameter is explained.
When the programming unit shows a value for an individual system parameter, it is
possible to change the value by entering a new one. If the parameter is only to be
checked and not changed, the work is continued by the operator pressing ENTER
without entering any data.
Concluding actions:
When the check or change of individual system parameters under the modes CHANGE
or RESOLV is completed, the operation is concluded by pressing ACTIVE in the basic
menu.
A full list of parameters and keywords is included at the end of this chapter, see section
5.6.
5.1.3
Handling system parameters to or from a diskette
Storage to diskette
Function Storage of active system parameters from the parameter memory to the diskette.
First insert a formatted diskette in the disk drive unit. The diskette may contain
associated program blocks.
Menu TO DISK from the main menu.
Note No initialization of the system is performed after this operation.
Loading from diskette
Function Loading of reserve-stored system parameters from diskette to the parameter
memory. First insert a diskette containing the required system parameters in the
disk drive unit.
Menu FR DISK from the main menu.
Check questions
The system concludes with check questions and initialization as
described in section 5.1.5.
INSTALLATION
S3
5:3
To Next Page
Loading...
