6 Reference information
6.8. Special tools
267 3HAC022032-001 Revision: E
© Copyright 2004-2008 ABB. All rights reserved.
Special tools
The table below specifies the special tools required during several of the service procedures.
The tools may be ordered separately and are also specified directly in concerned instructions
in the Product manual, procedures.
Description Qty Art. no.
Fixture lower arm 1 3HAC020584-001
3HAC020729-001
3HAC13660-1
Gearbox crank 1 3HAC16488-1
Gearbox crank, axis 2 1 3HAC020999-001
Guide pins M12 x 130 2 3HAC022637-001
Guide pins M12 x 150 2 3HAC13056-2
Guide pins M12 x 200 2 3HAC13056-3
Guide pins M12 x 250 1 3HAC13056-4
Guide pins M16 x 150 2 3HAC13120-2
Guide pins M16 x 200 2 3HAC13120-3
Guide pins M16 x 250 1 3HAC13120-4
Guide pins M16 x 300 2 3HAC13120-5
Guide pins, sealing ax 2/3, 100mm 1 3HAC14628-2
3HAC14627-3
Guide pins, sealing ax 2/3, 80mm 1 3HAC14628-1
3HAC14627-2
Hydraulic cylinder 1
2
3HAC11731-1
Hydraulic pump, 80 MPa 1 3HAC13086-1
Hydraulic pump, 150 MPa (Glycerin) 1 3HAC021563-012
Hydraulic valve with hose 1 3HAC022643-001
Lifting device, base 1 3HAC15560-1
Lifting device, manipulator 1 3HAC15607-1
Lifting device, upper arm 1 3HAC15994-1
3HAC15536-1
Lifting eye VLBG M12 1 3HAC16131-1
Lifting eye M12 2 3HAC14457-3
Lifting eye M16 2 3HAC14457-4
Lifting tool (chain) 1 3HAC15556-1
Lifting tool, gearbox axis 2 1 3HAC13698-1
3HAC020386-001
3HAC12731-1
Measuring tool 1 6896134-GN
Motor press pinion 1 3HAC021883-001
Oil injector / max 500 MPa 1 3HAC021590-001
Press tool, axis 2 bearing 1 3HAC13527-1
3HAC13453-1
Puller device, axis 2 shaft 1 3HAC021563-001
Continued
Continues on next page
To Next Page
Loading...
