6 Reference information
6.8. Special tools
3HAC022032-001 Revision: E272
© Copyright 2004-2008 ABB. All rights reserved.
Mounting tool, tilthouse shaft
The tool for fitting the tilthouse shaft to the tilthouse is assembled with the parts shown in the
figure below (included in the toolkit for service).
Note! The parts cannot be ordered separately, but are included in the complete toolkit! The
article numbers are given only for identification.
xx0500002581
A Hydraulic cylinder, 3HAC11731-1
B Press washer, 3HAC023963-007
C Hex socket head cap screw, 9ADA183-25, 2 pcs, M6 x 25
D Connection rod, M16, length= 400 mm
E Nut, 3HAC5507-1
J Pad, 3HAC023963-029
K Press washer, 3HAC023963-014
Continued
Continues on next page
To Next Page
Loading...
