2 Installation and commissioning
2.4.4. Electrically restricting the working range of axis 3
3HAC022032-001 Revision: E74
© Copyright 2004-2008 ABB. All rights reserved.
Required equipment
Fitting, electrical stop axis 3
The procedure below details how to fit the electrical stop to axis 3.
Mounting instructions are also supplied with the kit.
Equipment, etc.
Spare part
no.
Art. no. Note
Electrical stop, axis 3 3HAB 3795-1 Includes all spare parts shown
in the figure Electrical stop on
page 73.
Locking liquid Loctite 243
Standard toolkit 3HAC 17594-1 The contents are defined in
section Standard toolkit on
page 264.
Other tools and
procedures may be
required. See references
to these procedures in the
step-by-step instructions
below.
These procedures include
references to the tools
required.
Circuit Diagrams See chapter Circuit diagram in
the Product manual, reference
information.
Action Info/Illustration
1. Remove the covers (A) from axis 3.
xx0300000263
2. All screws are locked with locking liquid, when fitted. Specified in Required
equipment on page 74.
3. Fit the electrical stop according to the figure Electrical
stop on page 73.
Continued
To Next Page
Loading...
