2 DressPack and SpotPack
2.4.2 Configuration result for Type Se
74 Rev.E 3HAC 025861-001
Required Spot Welding cabinet options
The SpotPack IRB 6620 also requires a Spot Welding cabinet (option 768-3) to
perform as intended. There are three different variants (see below) of Spot Welding
cabinets available. Weld timer brand and weld capacity are stated by choosing one of
the optional variants. Additional features could then be added to each cabinet variant.
All these options are further described under chapter 2.6 Spot Welding cabinet and
are also mentioned in this chapter.
Figure 49 Spot Welding cabinet overview.
Additional options to the different Spot Welding cabinets are mentioned below. For
further technical details as well as restrictions in combinations see
chapter 2.6 Spot Welding cabinet
Option Type Description
782-1 Bosch Basic AC This option gives a basic Spot Welding cabinet
equipped with a weld timer from Bosch with an
integrated AC-thyristor with basic capacity.
Type Bosch PST 6100.630L1.
782-2 Bosch Compact AC This option gives a basic Spot Welding cabinet
equipped with a weld timer from Bosch with an
integrated AC-thyristor with basic capacity.
Type Bosch PST 610E.
782-7 Bosch Basic MFDC This option gives a basic Spot Welding cabinet
equipped with a weld timer from Bosch with an
integrated inverter with basic capacity.
Type Bosch PSI 6100.630L1.
Option Type Description
788-1 Forced air cooling Offers a cooling fan with housing placed on the rear
of the Spot Welding cabinet which forces air on the
cooling surface/grids of the thyristor or MFDC
inverter.
789-1 Earth fault protection unit Offers an earth fault protection integrated with the
circuit breaker for the weld power.
790-1 Contactor for weld power Offers a weld contactor with necessary wiring placed
inside the Spot Welding cabinet.
791-1 Weld power cable, 7 m Offers floor cable of 7 m length for weld power.
791-2 Weld power cable, 15 m Offers floor cable of 15 m length for weld power.
To Next Page
Loading...
