ABB IRB 6620 - Page 85

2 DressPack and SpotPack
2.5.2 Configuration result for Type HSe
3HAC 025861-001 Rev.E 83
Additional options to the different Spot Welding cabinets are mentioned below. For
further technical details as well as restrictions in combinations see
chapter 2.6 Spot Welding cabinet.
782-7 Bosch Basic MFDC This option gives a basic Spot Welding cabinet
equipped with a weld timer from Bosch with an
integrated inverter with basic capacity.
Type Bosch PSI 6100.630L1.
Option Type Description
788-1 Forced air cooling Offers a cooling fan with housing placed on the rear
of the Spot Welding cabinet which forces air on the
cooling surface/grids of the thyristor or
MFDC inverter.
789-1 Earth fault protection unit Offers an earth fault protection integrated with the
circuit breaker for the weld power.
790-1 Contactor for weld power Offers a weld contactor with necessary wiring placed
inside the Spot Welding cabinet.
791-1 Weld power cable, 7 m Offers floor cable of 7 m length for weld power.
791-2 Weld power cable, 15 m Offers floor cable of 15 m length for weld power.
809-1 Process cable to stationary
gun, 7 m
Offers floor cable of 7 m length for process signals
between the Spot Welding cabinet and to the
stationary gun.
809-2 Process cable to stationary
gun, 15 m
Offers floor cable of 15 m length for process signals
between the Spot Welding cabinet and to the
stationary gun.
809-3 Process cable to stationary
gun, 22 m
Offers floor cable of 22 m length for process signals
between the Spot Welding cabinet and to the
stationary gun.
809-4 Process cable to stationary
gun, 30 m
Offers floor cable of 30 m length for process signals
between the Spot Welding cabinet and to the
stationary gun.
Option Type Description