ABB M2000 - Page 317

4 Repair
4.5.3. Replacement of balancing device
3153HAC022033-001 Revision: K
© Copyright 2004-2011 ABB. All rights reserved.
2. Pull out the sealing spacers, but let them still
remain on the ear.
• Apply rust preventive abundantly in the
gap
• press the sealing back in place
• wipe off surplus material.
xx0600003131
• A: Sealing spacers
3. Apply Mercasol 3106 to the shaft and hole in
frame.
xx0600003130
• A: Mercasol on shaft and in
hole
• B: Mercasol between piston
rod and ear
4.
DANGER!
Make sure all safety requirements are met when
performing the first test run. These are further
detailed in the section DANGER - First test run
may cause injury or damage! on page 47.
Action Note
Continued
工控帮助教小舒QQ2823408167
长沙工控帮教育科技有限公司