2 Installation and commissioning
2.3. Securing the robot
613HAC022033-001 Revision: K
© Copyright 2004-2011 ABB. All rights reserved.
2.3. Securing the robot
General
This section describes how to secure the robot using the transport support.
DANGER!
Releasing the brakes is a hazardous action that may cause injury and damage property. It must
be done with great care and only when absolutely necessary.
Securing the robot
xx0800000062
Action Note
1. Mount the transport support’s lower end
to the robot using the recommended
screw joint, (A) in figure.
Do not tighten the screw.
See attachment point for the specific robot in
the section Transport position with a
transport support on page 57.
Continues on next page
To Next Page
Loading...
Need help?
General
