Note/IllustrationAction
Reconnect:
• A1.X13 - A2.X12
• A1.X2 - T4.X17
• A1.X11 - T4.X13
• A2.X13 - G1/G2.X1
• A1.X6 - A2.X11
5
xx2100001333
Insert the cable ties back to the locking
holes.
Tip
Refit the cable ties according to the
photo.
6
Refitting the incoming mains connector
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 28.
1
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 41.
2
xx2100001295
Insert the incoming mains connector into
the front panel of the cabinet.
3
Continues on next page
Product manual - OmniCore E10 133
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.3 Replacing the power unit
Continued
To Next Page
Loading...
