Removing the computer and logic unit
Note/IllustrationAction
xx2100001338
Remove the screws locking the computer
and logic unit.
1
Move the computer and logic unit back
a little to release the FlexPendent adaptor
connector from the front panel.
2
Remove the computer and logic unit.
ELECTROSTATIC DISCHARGE
(ESD)
When handling the computer outside of
the controller, use the wrist strap button
located on the side of the computer.
3
Refitting the computer and logic unit
Refitting the computer and logic unit
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 28.
1
Continues on next page
Product manual - OmniCore E10 143
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.5 Replacing the computer and logic unit
Continued
To Next Page
Loading...
