ScreenMaster RVG200
Paperless recorder 7 Configuration
104 OI/RVG200-EN
Count range
Preset count Set the value the totalizer counts from and the value applied when the
totalizer is reset.
Predetermined count Set the value at which the totalizer stops or wraps.
Note.
A counter configured to count up must have a Preset count value
lower than the Predetermined count value. A counter configured to
count down must have a Preset count value greater than the
Predetermined count value.
Set the required number of decimal places on the higher of the
Preset count value or Predetermined count value.
Intermediate count Set the value at which a digital source is activated (for example, this can
be used as an alarm threshold to indicate when the Predetermined count
value is about to be reached).
To Next Page
Loading...
