ScreenMaster RVG200
Paperless recorder Appendix E – Batch recording
OI/RVG200-EN 177
E.3 Configuration
E.3.1 Enabling batch security
To enable batch security, access Common Configuration (see Section 7.7.5, page 74) and select the
Security tab.
E.3.2 Configuring batch access privileges
To enable operators to manually control batches, access Common Configuration (see Section 7.7.6,
page 76) and select the User' tab.
Note. Batch security can be enabled only if the Security system parameter is set to Advanced – see
Section 7.7.5, page 74. If the Security system parameter is set to Basic, batch security is automatically
disabled and cannot be enabled.
Security
Security type Set the Security type.
Security system Set to Advanced to enable batch security.
User
User 1 Name Configure User 1 (System Administrator)
User 1 Access Ensure Batch is ticked to enable User 1 to start and stop batches – see
Section E.2, page 174.
Repeat as required for other users.
Refer to page 178 to set the required type of batch recording security.
To Next Page
Loading...
