ScreenMaster RVG200
Paperless recorder 7 Configuration
80 OI/RVG200-EN
7.8 Process group configuration
7.8.1 Setting the recording parameters
Fig. 7.9 Selecting process group configuration
Recording
Tag Enter a tag (maximum 20 characters) to identify the Process Group in the
title bar when any Operator view from that group is displayed.
Refer to Appendix F, page 180 for further information regarding character
use in tags.
Note. Each process group tag must be unique.
Recording enable source Select a signal source to enable / disable recording of all channels in the
current Process Group. Refer to Appendix A, page 146 for a description
of the available sources.
Note. This signal is edge-triggered. A rising edge (inactive to active)
enables recording. A falling edge (active to inactive) disables recording.
Only the number of groups selected for configuration are displayed in this sub-menu.
For example, if Number of groups (see page 68) is set to 4, only Process Groups 1 to 4 are displayed.
Enabled
Disabled
To Next Page
Loading...
