ScreenMaster RVG200
Paperless recorder 7 Configuration
76 OI/RVG200-EN
7.7.6 Users
Note.
User 1 is the System Administrator and is able to change user names / access privileges and enter
initial passwords for all other users.
if Security system is set to Basic (see Section 7.7.5, page 74) other users (if enabled by User 1) can
change their user name, password and access privileges.
if Security system is set to Advanced (see Section 7.7.5, page 74), other users cannot change their
user names and access privileges once set by User 1, but all users may change their own
passwords.
The following parameters are displayed only if Security system is set to Basic – see Section 7.7.5,
page 74.
User
User 1 Enter a name and password for User 1.
Note. User 1 only is able to access this parameter.
User 2 (to 4) User 1 can enter names and associated passwords to enable up to 3
additional users access to the Configuration level.
Note. If enabled by User 1, another user can access their associated
parameter and change the Name, Password and Access settings. However,
if Access is set to Disabled by that user and the configuration saved, only
User 1 can restore that user's access privileges.
Name Enter a name for the selected user.
Password Enter an initial password for the selected user.
Access Set access privileges for the selected user.
Enabled
Disabled
–
–
The selected user is able to access the Configuration level.
The selected user is unable to access the Configuration
level.
Note. When the method of access to the Configuration level is set to
Password protected (see Section 7.7.5, page 74) and a user with
Configuration level access privileges changes the recorder's
configuration, the Name of the user is included in the audit log entry.
To Next Page
Loading...
