ABB ScreenMaster RVG200 - Channel Configuration Details; Recording Channel Setup and Filters

ScreenMaster RVG200
Paperless recorder 7 Configuration
84 OI/RVG200-EN
7.8.3 Configuring the indicator view
Indicator
Indicator Select On to enable the Operator to display the Indicator view.
Totalizer / statistics Set to On to add the channel totalizer value and units to the Indicator
view.
Note. Available only if the totalizer option is enabled in the software and a
totalizer for that channel is enabled.
Bar graph display Set to On to add the Bargraph display to the Indicator view.
Note. Bargraphs are displayed only for groups with a maximum of 6
recording channels.
Alarm Trip Points Set to On to add the alarm trip point indicators to the bargraphs.
Menu enables Select the menu items to be accessible from the Indicator view.
Operator message
Totalizer stop / go
Totalizer reset
Show totalizers / statistics
Alarm acknowledge
–
–
–
–
–
Enables the Operator to activate one of
24 pre-configured messages or a
user-defined message.
Enables the Operator to start and stop
the totalizers.
Enables the Operator to reset the
totalizer value to the preset totalizer value
on any or all channels.
Enables the Operator to change the
display to show either the totalizer values
or the totalizer maximum, minimum and
average values.
Enables the Operator to acknowledge
any alarms associated with the current
group.
Note. Menu items that are not enabled are greyed-out in the Indicator
view menu.