7-3
Questions? Refer to Page 11-22 For Technical Support Instructions.
What You See on the Display What You Do Comments
4. Press Scan or manually enter the
Operator ID via the keypad, then press
Enter.
While the Operator ID may be up to 30
digits, not all digits will fit on the display.
The meter may also be set to truncate
(ignore) leading, trailing, and/or selected
digits of the barcode.
5. Select appropriate Linearity Panel.
If ketone testing is disabled, this screen will
not appear.
6. Scan or manually enter the CVC kit
lot number via the keypad, then press
Enter.
LIN stands for Linearity.
Note: You must use the same strip lot for the entire panel when performing a Linearity Test.
Chapter 7: Linearity Test
To Next Page
Loading...
