2-5
Questions? Refer to Page 11-22 For Technical Support Instructions.
Chapter 2: Using the Meter
Audible Indicator
e meter has an audible indicator that can be turned on or o. is indicator emits two tones, a high pitched tone to indicate
success and a low pitched tone to indicate a problem. If enabled, the meter will beep to indicate the following actions:
• The operator has successfully scanned a barcode;
• The meter has detected an adequate sample and is starting test analysis;
• The meter is nearing completion of test analysis (3 beeps with final countdown);
• The meter has displayed the test result;
• An error has occurred (see Chapter 11 for troubleshooting information);
• The meter will automatically shut off in thirty seconds (2 beeps);
• The operator has pressed an unexpected button;
• The operator has pressed the On/Off button.
Data Port
e data port is located at the bottom of the meter. is port enables the meter to automatically transfer the data through a cable
or docking station to the data management system. Data may be transferred through a cable or docking station even if the meter
is wireless enabled.
Battery Compartment
e meter holds two AA batteries to power the meter.
To Next Page
Loading...
