8-1
Questions? Refer to Page 11-22 For Technical Support Instructions.
Review Setup
Meter Configuration
e FreeStyle Precision Pro meter conguration settings are enabled via the data management system. ese settings can be
viewed on the hand-held device, but cannot be changed on it. Settings that are congured through the data management system
are:
Upload Interval
• Length of time between data uploads.
• Whether you can continue to test (“allow test” or “warn”) or not (“lockout”).
Operator ID
• Whether the Operator ID is required, optional, or not used for all tests.
• Define the Operator ID prompt.
• The minimum and maximum number (between 1 and 30) of digits that are acceptable for the Operator ID.
• With manual entry of the Operator ID, determine whether a check digit is required (modulus 10 or 11).
Note: Wireless enabled systems will transfer data automatically without user interaction. Non-wireless enabled
systems will require the user to utilise the docking station or cable to transfer data at specified intervals.
Chapter 8: Review Setup
To Next Page
Loading...
