3-23
Questions? Refer to Page 11-22 For Technical Support Instructions.
Patient Test Procedure - Ketone
Use the following procedure to perform patient tests with the FreeStyle Precision Pro Blood β-Ketone Test Strip and Precision
Xceed Pro Blood β-Ketone Test Strip. e FreeStyle Precision Pro meter recognises the type of test strip based on the scan of the
strip barcode.
What You See on the Display What You Do Comments
1. Follow steps 1 to 7 in the last section
on the Glucose Patient Test. Insert the
purple Blood β-Ketone Test Strip into
the test strip port until it stops and
Strip Inserted is displayed. The meter
will recognise the strip based on the
barcode.
Prior to inserting the test strip, ensure that
the strip port module is installed and that it
is clean and dry. Replace if necessary. The
display will alternate between Insert Strip
and Ketone.
Note: The following section illustrates some common settings. Depending on your facility’s specific settings,
some screens will display differently or not at all. If the meter does not display the screens shown,
please refer to Chapter 11, Troubleshooting.
Chapter 3: Patient Test
To Next Page
Loading...
