3-24
Questions? Refer to Page 11-22 For Technical Support Instructions.
What You See on the Display What You Do Comments
2. When Apply Sample is displayed,
apply a drop of blood from the patient's
finger, transfer pipette or syringe to the
target area of the test strip.
When sufficient sample has been applied,
the meter beeps, displays Sample
Accepted and automatically starts the test.
For a detailed description of the test strip
target area, refer to the Test Strips section of
Chapter 1.
3. Wait for the meter to analyse the sample
and display the test result.
The meter counts down then displays the
test result. If an error is detected during
the assay, the assay is terminated and no
result is displayed. Once the assay begins,
all key presses are ignored until the assay is
completed.
Chapter 3: Patient Test
To Next Page
Loading...
