5-6
Questions? Refer to Page 11-22 For Technical Support Instructions.
Data Review for Patient by Patient ID
Please refer to the beginning of this Data Review chapter for step-by-step instructions to access the Data Review menu.
What You See on the Display What You Do Comments
1. Press 2 to select Patient by PatID.
The meter shows test results for a specific
patient.
2. Press Scan to scan the Patient ID
barcode or manually enter the Patient
ID via the keypad (if enabled).
If you enter the ID manually, you may be
required to enter it a second time to ensure
it is correct.
While the Patient ID may be up to 30 digits,
not all digits will fit on the display. The
meter may also be set to truncate (ignore)
selected digits of the barcode.
Note: The following section illustrates some common settings. Depending on your facility’s specific settings,
some screens will display differently or not at all. If the meter does not display the screens shown,
please refer to Chapter 11, Troubleshooting.
Chapter 5: Data Review
To Next Page
Loading...
