8-6
Questions? Refer to Page 11-22 For Technical Support Instructions.
Review Setup
What You See on the Display What You Do Comments
1. Press On/Off to turn on the meter.
The Abbott logo screen will appear in
black for a few seconds and then will
appear in grey to ensure that the display is
functioning properly. Next, the software
version will briefly appear.
2. Press the Menu button. The meter starts in Test Mode. The Menu
button will toggle the meter to Menu
Mode.
Note: This section illustrates some representative settings.
If the meter does not display these screens, please refer to Chapter 11, Troubleshooting.
Chapter 8: Review Setup
To Next Page
Loading...
