7-1
Questions? Refer to Page 11-22 For Technical Support Instructions.
Linearity Test
e Linearity Test menu enables you to verify method linearity using an RNA Medical
®
brand Calibration Verication Control
(CVC) kit. ese kits contain assayed materials for use in conrming the calibration and linearity of glucose and ketone at the
upper and lower limits of the reportable range and at three (3) points within the range. CVC kits are designed for specic test
strip types. Please refer to the CVC package insert for compatible test strip types and detailed instructions for use.
Please use the following procedure to perform a Linearity Test. is functionality may or may not be available depending on the
conguration of the meter through the data management system.
Note: This section is only for Point-of-Care Coordinators, not operators. It illustrates some common settings.
Depending on your facility’s specific settings, some screens will display differently or not at all. If the
meter does not display the screens shown, please refer to Chapter 11, Troubleshooting.
IMPORTANT: Patient testing should be run in Patient Test mode only. Results obtained in Linearity
Test mode should only be used to assess system linearity performance.
Chapter 7: Linearity Test
To Next Page
Loading...
