Machine Maintenance Procedures 3-41
LCD Bezel Installation 0
1. Locate bezel hinges covers (B) on LCD cover (Figure 3-41).
Make sure LCD cables pass through hinge wells and are not trapped by bezel.
2. Secure hinge covers to LCD module cover hinge wells.
3. Starting from bottom-center of bezel, secure bezel to LCD cover latches. Move along edge
until bezel is completely secured. (Figure 3-42)
4. Install and secure two (2) screws (A) and mylar covers to bezel. (Figure 3-41)
5. Install LCD Module.
ID Size Quantity Image
C M2x4 Ni 2
To Next Page
Loading...
