System Utilities 2-23
Cleaning BIOS Passwords 0
To clean the User or Supervisor passwords, perform the following steps:
1. At the DOS prompt, enter clnpwd.exe.
2. Press 1 or 2 to clean the desired password as shown in Figure 2-26.
Figure 2-26. Clean BIOS Password
3. The on screen message shows function success or failure.
D:\Clnpwd>clnpwd
Acer Clean Password Utility V1.00
Press 1 or 2 to clean any password shown as
below
1. User Password
2. Supervisor Password
Clean User Password Successful!
To Next Page
Loading...
