3-42 Machine Maintenance Procedures
CCD (Charge-Coupled Device) Module Removal 0
Prerequisite:
LCD Bezel Removal
1. Locate CCD module (A) on LCD module cover. (Figure 3-43)
Figure 3-43. LCD Module Overview without Bezel
2. Remove module cable (F) from module connector (G). (Figure 3-44)
Figure 3-44. CCD Module with Cable
3. Remove module (H) from adhesive strip on LCD cover.
CCD (Charge-Coupled Device) Module Installation 0
1. Install and secure module (H) to LCD module cover (Figure 3-44).
2. Install module cable (F) to module connector (G).
3. Install LCD Bezel.
To Next Page
Loading...
