ACIST CVi - Patient Kits; Select Mode; End Case; System Messages Area

Patient Kits
28 | English (USA) 2019-08 901418-003,01 ACIST | CVi® System User's Guide
3 System Description
Select Mode
Initiates the following three modes of operation:
• Inject – To arm the system in preparation for injecting contrast.
• Saline – To ush the system with 0.9% normal saline.
• Purge – To run contrast through the system in order to purge air.
• KVO – To initiate the KVO (keep vessel open) function, which provides a
periodic pulse of saline between injections. e KVO function is available
only in peripheral procedure mode.
End Case
Starts the end-of-case procedure for changing out single use components and,
if desired, shutting down the system.
System Messages Area
System messages and alerts are displayed in this area of the screen.
Before the CVi system is used, the patient kits are loaded onto the injector. e
system is to be used only with ACIST-provided patient kits, and only those kits
that are intended for use with the CVi system.
e CVi system currently uses the following patient kits:
Model Number Model Name Uses
BT2000 Manifold Kit Single Use
AT P54
AT P65
AngioTouch Hand Controller Kit Single Use
A2000 Syringe Kit Up to six cases
Patient Kits